LISEC Waterjet  

 


Combined Vertical Waterjet-Cutting and Edge-Working Center, Type WSL

Vertical machine with entirely new prospects for cutting, cut-out of holes of any shape and treatment of the cutting edges of glass sheetsresp. any other sheet material. The vertical arrangement of the machine and the combined roller/clamping-beam transport device enables an easy handling even of large workpieces and therefore provides the basis for a continuous process controlled production sequence of plates one after the other. The new construction guarantees a silent operation, the big water collection tanks known from horizontal machines are omitted by the new Lisec jet-catching-system.


The characteristic feature of its jet technique, which makes it different from known machines, is the freely located surrounding of the jet point on the workpiece in any position and dimension. This new system avoids expensive sacrificial material. In addition the workpiece, especially glass sheets, will not be damaged on its surface by any jet reflection as known from established machines. Integrated additional edge working tools enable a unrivalled range of utilization of this multifunction processing center. Milling-, grinding- and countersinking bits are working
both front and back side of the lite fully automatic in one go. The integrated recycling plant for the abrasive material means another reduction of operation cost.



Special Advangages:

1.) High accuracy of cutting resp. edge working by direct-drive positioning of working head
2.) Cutting/eging even possible in clamping/transport area of glass edge
3.) No extra saw device required
4.) Less operating cost compared to pure milling machines
5.) Comprehensive production even of complex shapes without any additional handling or finishing
6.) Reduced floor space requirements and ergonomical work due to vertical arrangement of machine
7.) Avoids micro-cracks compared to usual glass cutting
8.) Low no. of tools required, cut-outs not restricted to min. diameters
- 1- or 2-side seaming of sharp edges

- Countersinking of hole cuts on both sides

- Grinding and polishing of the entire cutting edge

- Straight or shape cuts of extra thick glass